Can You Put a 23mm Tire On a 25mm Rim? (fast answer)
Condensed Answer: If the rim has а 25mm external width, then there's a high chance that it will work just fine with a 23mm tire. If the internal rim width…
Can You Put a 25mm Tire On a 21mm Rim? (fast answer)
Condensed answer: 25mm tires can be installed on rims with a 21mm internal rim width. However, there are some downsides to this combination. Average road rims have a 15-18mm internal…
Mullet Bikes Can Jump But Aren’t Ideal
Condensed Answer: A mullet bike facilitates jumping because the rear wheel is lighter, easier to lift, and less likely to come in contact with the rider's body during a jump.…
27.5″ Wheels Are Hurt, But Still Alive!
27.5" wheels and bikes aren't dead yet, but the data shows that their glory days are over.Manufacturers produce what sells and see little incentive to offer a wide spectrum of…
Are 2.6″ Tires The Right Size For 40mm Rims?
Condensed Info: 2.6" tires can technically be installed on rims with 40mm internal width, but in most cases, they will be too narrow. 40mm rims are designed for 3" or…
Are 2.4″ Tires a Good Fit For a 35mm Rim?
35mm rims are normally combined with 2.8"+ tires. Nonetheless, a 2.4" tire can still be installed on a 35mm rim. In some cases, the fit could be a bit tight,…
Learn Why BMX Tires Are “Fatter”
Condensed Answer: BMX tires are fat (wide) for the following reasons: Suspension effect Lower chances of getting a flat tire Rim protection Extra Grip Wider Tires = Softer Ride Wider…
Can You Put BMX Pedals On a Road Bike? (fastest answer ever)
Condensed Answer: A road bike can readily accept a set of BMX pedals that are 9/16″ x 20 in size. However, 1/2″ BMX pedals cannot be installed on a road…
The Magic Behind The Self-Tightening Capabilities of Bicycle Pedals
Bike pedals self-tighten as the rider pedals. This is accomplished via the strategic choice of thread direction on the pedal axles. The drive-side pedal tightens clockwise while the non-drive-side pedal…
Inflating a Bike Tire With a Ball Pump – Good or Bad?
Condensed answer: If the pump is designed for balls, it could lack the adapters needed for the Schrader and Presta valves found on bike tires. As a result, the pump…